Medisana CardioCompact Manuel d'instructions télécharger pdf (Page 38)

3 Getting started

3.5 Set alarm

Adjust the display tilt angle in that way, that the marking of the tilt

mechanism

indicates “Travelling clock mode”.

Press and hold the SNOOZE-button

for at least approx. 2

seconds, until the alarm state of the rst alarm

ashes (ON

or OFF).

Press the MEM-button

to change the state of the alarm. You

can select ON (activates alarm) or OFF (deactivates alarm).

Press the SNOOZE-button

to continue with the next step.

Follow the same steps (MEM-button

to adjust, SNOOZE-but-

ton

to continue with the next value) to enter the correct values

for hour and minute.

After that, you may enter a second alarm time

according to the

same scheme.

You may leave the alarm setting mode at any time by pressing

the START-button

. After approx. 1 minute without pressing any

button the device automatically leaves the alarm setting mode.

If the batteries are removed, these values are lost and need to be

input again.

•

NOTES:

- The alarm only will be effective in Travelling

clock and blood pressure measurement modes

(not in OFF mode).

- The alarm settings are only referring to the

regular clock - even if a second time zone

has been set according to chapter 3.4 Set date

and time.

- Press “MEM”

or “START”

to stop the

alarm or press the “SNOOZE”-button

and the

device will alarm again after 10 minutes.

- If no button is pressed within 50 seconds

during alarming, the alarm will be paused and

will alarm again after 10 minutes. If still no

button is pressed after 5 of the procedures, the

alarm will be cancelled.

51098 Travel GA West AM Master.indd 38 27.09.2012 12:29:18

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 209 210

Commentaires sur ces manuels

Pas de commentaire

Medisana CardioCompact Manuel d'instructions Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Unités de pression artérielle Medisana CardioCompact